Dynalco UM-600 Universal Monitor Uživatelský manuál

5450 NW 33rd Ave, Suite 104 Fort Lauderdale, FL 33309 3211 Fruitland Ave Los Angeles, CA 90058 UM-600 6-Channel Monitor Version 2 Installatio

9A description of each menu item follows: “Run Signal” There are (3) run types available. The definitions are as follows: None: No run indicatio

10”Calibration” Select the channel number to configure by pressing the up / down arrows and pressing the right arrow to select and continue. The

11”Data Logging” The UM-600 can be configured to log any of the parameters being monitored, at user defined time intervals. The values are saved

12Example # 2: To configure data logging of an input value following engine warm up: (Note that this configuration will require an input si

13start delay. If you wanted to continuously log the value, you would select the frequency in minutes between data logs. Selecting escap

14Alarm Outputs The UM-600 will alarm when channel values or differential values are above or below limits as specified. Alarms can be configur

15Downloading logged values to PC: The hardware connection from the UM-600 Monitor to a PC is via a USB cable assembly, Dynalco p/n 27

16Modbus Communication The unit also provides access to the internal registered values using the Modbus Protocol. The diagram below shows

17Modbus Address Registers: The Modbus address registers are defined in the tables below. Input Register Table (table 1) Modicon Address Modbus Of

18300017 16 Channel 5 High Alarm Limit -32768 32767 16 bit signed integer 300018 17 Channel 6 High Alarm Limit -32768 32767 16 bit signed integer 330

1IMPORTANT - PLEASE READ BEFORE PROCEEDING! This manual applies to all Version2 UM-600 Monitors. The Dynalco model UM-600 is designed for reliable

19301046-301049 1045-1048 Log Buffer Entry #12 Custom (See table 4) 301050-301053 1049-1052 Log Buffer Entry #13 Custom (See table 4) 301054-

20302006-302007 2005-2006 Channel 3 Float Value -9999.0 99999.0 32 bit Float(IEEE 754) 302008-302009 2007-2008 Channel 4 Float Value -9999.0 99999.0

21302048-302049 2047-2048 Channel 6 High Low Limit -9999.0 99999.0 32 bit Float(IEEE 754) 302050-302051 2049-2050 Channel 1 and 2 Differential Low Al

22

2System Overview The Dynalco model UM-600 is a universal monitor capable of reading up to 6 input channels, calculating differential values, prov

3Additional Features • 5 - Digit Hourmeter Function (non-resettable) • Engine RPM Display • Fully programmable from front keypad • ¼ DIN pack

4The UM-600 has integral mounting clips for securing into the panel. The following drawings illustrate the mounting procedure.

5Terminal Connections All connections are made via the removable connectors on the back of the unit. PIN Description PIN Description 1 GND

6Outline Dimensions

7Programming Overview All programming is accomplished through the front keypad. Below is a brief description of each key. Press to enter or exit t

8Programming Instructions Important: The UM-600 universal monitor must first be programmed prior to operation. When first powering up the unit, the